The spec is only useful if someone checks it
A grab bar mounted 6 inches off spec, or into drywall instead of a stud, can fail exactly when it’s needed most. That’s the whole reason we measure and confirm stud locations on every visit before drilling — see our full grab bar lineup for the styles we install to these standards.
Features
- 33″–36″ Mounting height Measured from the finished floor to the top of the gripping surface. This range keeps the bar reachable whether someone is pushing up from a seated position or steadying themselves while standing.
- 1.25″–1.5″ Grip diameter Thin enough that most adult hands can close fully around it, thick enough that it doesn't flex under a sudden load. Anything much thinner or thicker reduces grip security.
- 1.5″ Wall clearance The gap kept between the bar and the wall behind it, so fingers can wrap all the way around without knuckles scraping the wall surface.
- 250 lb Minimum load rating The baseline force a properly stud-anchored bar and its mounting hardware must withstand. Most of our Moen grab bars are rated well above this floor, up to 500 lbs.
- Stud-anchored Mounting method Drywall anchors alone can't reliably hold a load-bearing grab bar. Every install we do locates and anchors into structural studs or blocking, not just the wall surface.
